+2
Planned

Dieline 0427 production problem

Chris Davey 8 months ago updated by Joshua Baldwin 4 months ago 2

Hi,

I have created a box using dieline 0427 and produced a mockup on our Zund.

However the dieline does not take into account the front tabs.


For purpose of illustration, I have adjusted the fold angle to 85degrees - you can see that with the BFlute (3mm), the fold allowance in the dieline is 6mm, so the return tab does not have enough space to slide back into a recess (refer to top left hand corner of image where tab is meant to slide in in, and bottom left hand side of image to show there is not a 3mm gap that will allow the tab to slide in).

Planned

Hello Chris,

Thanks, we're going to address this in the next update of the platform. Sorry about the issue.

Cheers!

I have noted this same issue with 0427 cartons, some tolerances (particularly front lfaps) are incredibly tight.